Explore Marking Gauge, Hole In One, and more!

Hole in one makes an above-par marking gauge | WOOD Magazine

By drilling a [fraction hole in the center channel of a combination square at the mark, I can easily lay out exact, parallel pencil lines.

Shop Tips | Page 10 | WOOD Magazine

When drilling holes, the bit suddenly breaking through the workpiece can cause the chuck jaws to bump into the workpiece.

Adding 1-13/16 in. to 3-3/8 in. (or any other fractions) doesn't have to hurt. Just line up two rulers or tape measures side by side and read the answer instantly, with complete accuracy. It works for subtraction, too—just read the numbers in the other direction.

Measuring Tips and Techniques for DIYers

Adding in. (or any other fractions) doesn't have to hurt. Just line up two rulers or tape measures side by side and read the answer instantly, with complete accuracy. It works for subtraction, too—just read the numbers in the other direction.

Self Centering Jig - Drill Tips, Jigs and Fixtures | WoodArchivist.com

Self Centering Jig - Drill Tips, Jigs and Fixtures - Woodwork, Woodworking, Woodworking Plans, Woodworking Projects

mit computerMicro

WoodArchivist is a Woodworking resource site which focuses on Woodworking Projects, Plans, Tips, Jigs, Tools

Shop Tips | Page 8 | WOOD Magazine

For better access to the edges of workpieces while finishing, I rest them on pronged mending plates.

Buy Rotape Beam Compass at Woodcraft.com

Beam Compass

This compact self-measuring beam compass draws circles or arcs with a 2 to 72 radius Set the tape at the desired radius locate the center point and draw your arc or circle

Скрытое соединение и сверло Форстнера | WikiHomia

Teds Woodworking® - Woodworking Plans & Projects With Videos - Custom Carpentry — TedsWoodworking

Easy way find center circle with common shop tools

Skill Builder: How to Find the Center of Any Circle

If you need to drill a hole in the center of a circle, you’ll have to find it first. Use simple measuring tools and these easy methods to mark the point.

Shop Tips | Page 4 | WOOD Magazine

Recessing T-nuts flush with the surface of a shop jig requires at least two bit changes with standard drill bits.

Pinterest
Search